BRUSHES - POWERTOOLSA

YOUR ONE STOP SUPPLIER OF REPLACEMENT CARBON BRUSHES.

Carbon brushes for all types of imported and branded electric
motors, power tools and garden machinery. We supply the carbon
brushes that keep your store branded power tools going.

SELECT YOUR BRAND FROM THE MENU BELOW

To find out about the carbon brushes you require just click on
the contact us link . Don’t worry if you only have
some of the details. If you can include the make and model it
helps but DYNAMIC ELECTRICAL
will contact you back if further details are required.

FITTING OF
CARBON BRUSHES

When carbon brushes are replaced on a machine, they should be
allowed to run under no load for approximately 20 minutes prior
to use. This allows the brushes to bed in. It should be noted
that, the running times will be reduced, should the following
guide lines not be followed:

1st set of brushes	+/– 300 Hours
2nd set of brushes	+/– 150 hours
3rd set of brushes	+/– 75 hours
4th set of brushes	+/– 30 hours
5th set of brushes	+/– 13 hours

These guidelines are
further influenced if the tool is used in an enviroment where it
is exposed to abrasive dust. This
would shorten the life of
brushes.

N.B. Especially on 230mm Angle grinders when chasing.

SERVICING INTERVALS FOR POWER
TOOLS

All power tools should be serviced on a regular basis.
Intervals will be determined by the average daily use of the
machine.

The following is only a general guideline:

2 Hours 6 Months

4 Hours 3 Months

6 Hours 2 Months

8 Hours 1-2 Months

My Shopping Cart